|
|
Welcome to shuttermanufacture, where we bring excellence to your home. Our wide variety of products and services are of the finest quality and prepared to meet your expectations on any budget. Our goal is to please our customers…this is why our services revolve around your custom needs.
We are a licensed and bonded manufacture. We pride ourselves in building our products from the ground up, so you may receive the most accurate measurements and installations possible. Our many years of experience have allowed us to conduct all of our services in-house, eliminating the need for sub-contractors. To protect your property and to avoid delays, you should only hire licensed contractors with the finest expertise like us.
All our products come with a lifetime guarantee; therefore any repairs needed on our products are always free of charge. Please do not hesitate to call us if any service repair or replacement is needed, we are always here to help!
Measuring to order shutters is much easier than you think.
Remember these important things:
1. Use a steel measuring tape
2. Measure to the nearest eighth of an inch - don't round off
measurements.
3. Indicate clearly the width and height. Remember width first,
then height.
4. Remember for Inside Mount Only - measure the EXACT WINDOW
SIZE OPENING. Do NOT take deductions. Our factory takes those
allowances.
5. Remember for Outside Mount Only - Follow the details below
|
Outside Mount
In all cases make sure you measure top middle and bottom for
height and left, right and middle for width. The reason is
windows are often uneven. |
1. Measure window width in 2 different places, at the top and at the bottom of the window.
2. Measure window height in 2 different places, from the top of the sill to the top of the window frame. NOTE: If you have a marble or tiled sill the sill can be covered by the shutter. In this case your height measurement needs to be taken from under the sill to the top of the window.
3. Measure the sill projection, also in 3 places. Left, middle, and right. If the projection is more than 3/4" this must be indicated. The shutter frame must be made to accommodate this condition.
4. In conditions where there is less than 1 5/8" from the top of the window to the ceiling, moulding or any shelving above please indicate. This would be noted as a max top. Also indicate if there is less than 1 5/8" from the bottom of the window to the floor, moulding or piece of furniture below. This would be noted as a max bottom.
5. In conditions where there is less than 1 5/8" on either side of the window because of another wall or built in furniture exists please indicate. This would be noted as a max left, or a max right.
6. The frames of the shutters are 1 5/8" wide. Clearance less than that will interfere with your installation if you do not indicate this.
|
Inside Mount
In all cases make sure you measure top middle and bottom
for height and left, right and middle for width. The
reason is windows are often uneven. |
1. Measure window
width in 3 different places. Top, middle and bottom. Give us the
smallest measurement.
2. Measure window height in 3 different places. Left, middle and
right. Give us the smallest measurement.
3. Give us exact measurements. We will make the proper
deductions to fit your opening.
4. Inside mounted shutters need to have a clearance in the depth
(front to back) of 2 1/2". Inside mounted shutters come with or
without sill plate. We welcome you to email us pictures of your
windows if you are unsure of the measuring process.
Feel free to contact us for repair our product and installation.
|
|
|
|